![]() ![]() It would be very nice if at the least I could manually restart the network. 7 Answers Sorted by: 28 It is just saying that the restart option is going away /etc/init.d/networking stop /etc/init.d/networking start Note there is one line only That is important when running network restart through the network. Yes, I know Jessie is in testing and 100% reliability should not be expected, I'm just asking if there is something I am doing incorrectly.Īdditionally, if I restart networking using systemctl restart networking Perhaps the issue is due to the ethernet controller? I know people have had problems getting similar cards to work under wheezy, but support has been added in jessie. If you encounter issues, remove the interface name from the /etc/network/interfaces file, then restart the rvice. If I run lspci my ethernet card is 01:00.0 Network controller : Qualcomm Atheros AR9462 Wireless Network Adapter (rev 01)Ġ3:00.0 Ethernet controller : Qualcomm Atheros QCA8171 Gigabit Ethernet (rev 10) Be Careful, You should not flush IP Address through a. ![]() I'm running Jessie because my ethernet card wasn't supported in wheezy. Then restart the Ubuntu networking service using systemctl command. I don't know why it stops working and why it won't come back online. ![]() I'm running Debian Jessie and every few days my network will stop working under heavy load, not allowing any connections in or out. sudo /etc/init.d/networking start You can also run Debian Linux with systemd: sudo systemctl restart networking How to restart network from the command-line In this section, to restart the network from the command line, you have the following 4 options that you can use. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |